Thermosoft manufactures its FiberThermics® radiant floor heating element with a superior floor underlayment to bring you this most innovative electric floor warming system for all types of floating floors: laminate floors, engineered wood floors, natural wood floors, etc.

Here is what you should know about this most revolutionary radiant flooring system:

• There is no easier radiant floor heating system to install under laminates. Simply roll out the heating pads over the sub-floor. Duct-tape pads together at the seams and fill-in unheated spaces with non-heated Insulayment™ or any generic underlayment. Then lay your laminate floor per manufacturer instructions. The heating elements are pre-spaced and factory-mounted on the underlayment pad. No hot water pipes to worry about or thick electrical cables to bury in cement or raise your floor.
  
  
• ThermoFloor™ radiant under floor heating is ideal for adding safe, low cost warmth to your kitchen, family room, basement or any other room in your home.
  
  
• ThermoFloor™ electric floor warming systems serve as an insulator of the slab below. ThermoFloor has an R value = 0.50 (1/8" thick x R=4 per inch). Always use a vapor barrier between the slab and our floating floor underfloor heating systems.
  
  
• ThermoFloor™ is a sound barrier. It has a Field Impact Insulation Class (FIIC) rating of 60 which exceeds the International Building Code Standard of 50. Therefore, it is suitable for installations in condominums and other multiple story buildings where sound transmission is a concern.
  
  
• ThermoFloor™ electric under floor heating comes in four convenient sizes: 1.5' x 5' covering 7.5 S.F.; 1.5' x 10' covering 15 S.F.; 3' x 5' covering 15 S.F and 3' x 10' covering 30 S.F. Lay out your floor plan with these four sizes to cover the main living areas where people will be standing, sitting or walking, and fill in the remaining areas with unheated Insulayment™ or generic underlayment.
  
  
• ThermoFloor™ warming systems are ideal for glued-down floors, engineered or natural wood. Simply glue down Floating Floor Warmth to the subfloor, then glue down the wood floor to Floating Floor Warmth.
  
  
• ThermoFloor™ electric floor warming can be used as a supplemental or sole source heater. Each pad generates 10 Watts per S.F. The more coverage, the more suited for sole source heating. Call us for assistance in determining your BTU requirements.
  
  
• ThermoFloor™ under floor heating connects to your regular 110/120V AC household electric wiring. Run the pre-connected 20' lead wires from the end of the pad to your thermostat electric box. Connect multiple radiant floor heating pads in parallel to one thermostat. For maximum energy savings, use our programmable thermostat. Always connect Floating Floor Warmth to a circuit protected by GFCI (ground fault circuit interrupt). Our programmable thermostats include GFCI.